Коды ошибок в Canon 9800

E000 The surface temperature of the fixing assembly upper roller fails to rise by a specified value within 90 sec after power-on. The surface temperature of the fixing assembly upper roller fails to reach 150C within 8 min after power-on
E001 The surface temperature of the fixing assembly upper roller exceeds 250C
E005 The cleaning belt inside the fixing assembly has been taken up more than a specified length
E010 After generation of the main motor drive signal, two or more pulses are not received within 2 sec
E013 The error detection circuit on the waste toner feed motor driver PCB has detected an overcurrent
E020 The accumulative time during which the toner supply signal (TSP) has been generated by the developing assembly reaches 3 min*
E050 The holding tray home position signal (THP) is not generated within 4 sec while the holding tray motor drive signal (TMDP1, 2) is being generated. The holding tray home position signal (THP) is generated 1 sec or more while the holding tray motor drive signal (TMDP1, 2) is being generated
E203 Input of two or more clock pulses is not received within 2 sec from the scanner motor drive signal is generated
E210 The lens home position signal (LHP) is not generated within 4.8 sec after power switch or door switch has gone ON. The lens home position signal (LHP) is generate 2 sec or more
E240 An error has occurred in the microprocessor on the DC controller PCB
E243 An error has occurred in the microprocessor of the DC controller PCB and the microprocessor in the control panel
E710 An error has occurred in the communication between the DC controller PCB and the controller PCB of the option, and the DC controller has detected the error
E712 No communication is perceived from the RF controller PCB for 200 ms or more the communication is monitored at all times